Datasheet search site | www.alldatasheet.com

DS26LS32CDS26LS32MDS26LS32ACDS26LS33CDS26LS33MDS26LS33AC DS26LS32C DS26LS32M DS26LS32AC DS26LS33CDS26LS33M DS26LS33AC Quad Differential LineReceivers The DS26LS32 and DS26LS32A are quad differential line High differential or common-mode input voltage ranges receivers designed to meet the RS-422 RS-423 and Feder- of g7V on the DS26LS32 and DS26LS32A and g15V al Standards 1020 and 1030 for balanced and unbalanced g 0 2V sensitivity over the input voltage range on the The DS26LS32 and DS26LS32A have an input sensitivity of DS26LS32 and DS26LS32A g0 5V sensitivity on the DS26LS33 and DS26LS33A have an input sensitivity of DS26LS32 and DS26LS32A meet all requirements of 500 mV over the input voltage range of g15V Both the DS26LS32A and DS26LS33A differ in function from the popular DS26LS32 and DS26LS33 in that input 100 mV input hysteresis on the DS26LS32 and pull-up and pull-down resistors are included which prevent Each version provides an enable and disable function com- mon to all four receivers and features TRI-STATE TRI-STATE outputs with choice of complementary out- with 8 mA sink capability Constructed using low power put enables for receiving directly onto a data bus Schottky processing these devices are available over thefull military and commerical operating temperature ranges Note Input conditions may be any combination not defined for ENABLE DS26LS32MJ DS26LS32ACM DS26LS32ACNDS26LS33CN DS26LS33MJ or DS26LS33ACNSee NS Package Number J16A M16A or N16A Order Number DS26LS32MJ 883 DS26LS32MW 883 is a registered trademark of National Semiconductor Corporation Absolute Maximum Ratings (Note 1)If Military Aerospace specified devices are required please contact the National Semiconductor Sales Office Distributors for availability and specifications Derate cavity package 9 6 mW C above 25 C derate molded DIP package Electrical Characteristics over the operating temperature range unless otherwise specified (Notes 2 3 and 4) VOUT e VOH DS26LS32 DS26LS32A b7V s VCM s a7V Note 1 ‘‘Absolute Maximum Ratings’’ are those values beyond which the safety of the device cannot be guaranteed They are not meant to imply that the deviceshould be operated at these limits The table of ‘‘Electrical Characteristics’’ provides conditions for actual device operation Note 2 All currents into device pins are shown as positive all currents out of device pins are shown as negative all voltages are referenced to ground unlessotherwise specified All values shown as max or min are so classified on absolute value basis Note 3 All typical values are VCC e 5V TA e 25 CNote 4 Only one output at a time should be shorted Switching Characteristics VCC e 5V TA e 25 C AC Test Circuit and Switching Time Waveforms Note 2 S1 and S2 of load circuit are closed except where shown Note 3 Pulse generator for all pulses Rate e 1 0 MHz ZO e 50X tr s 6 ns tf s 6 0 ns Order Number DS26LS32MJ DS26LS33MJ DS26LS32MJ 883 or DS26LS33MJ 883 Physical Dimensions inches (millimeters) (Continued) Order Number DS26LS32CN DS26LS32ACN DS26LS33CN or DS26LS33ACN Physical Dimensions inches (millimeters) (Continued) Order Number DS26LS32MW 883 or DS26LS33MW 883 NATIONAL’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORTDEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF NATIONALSEMICONDUCTOR CORPORATION As used herein 1 Life support devices or systems are devices or 2 A critical component is any component of a life systems which (a) are intended for surgical implant support device or system whose failure to perform can DS26LS32CDS26LS32MDS26LS32ACDS26LS33CDS26LS33MDS26LS33AC into the body or (b) support or sustain life and whose be reasonably expected to cause the failure of the life failure to perform when properly used in accordance support device or system or to affect its safety or with instructions for use provided in the labeling can be reasonably expected to result in a significant injuryto the user National does not assume any responsibility for use of any circuitry described no circuit patent licenses are implied and National reserves the right at any time without notice to change said circuitry and specifications

Source: http://www.elektronik.ropla.eu/pdf/stock/nsc/ds26ls33.pdf